tag:blogger.com,1999:blog-8119414028775734083.post3971732026080098982..comments2022-10-10T17:53:16.168-05:00Comments on Tron: Legacy Costume: orpexhttp://www.blogger.com/profile/14235298689095579884noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-8119414028775734083.post-15854941485301329812011-02-18T08:26:35.682-06:002011-02-18T08:26:35.682-06:00So I used a Dremel with a cut-off disc to remove t...So I used a Dremel with a cut-off disc to remove the excess plastic. On the back half of the disc I left the screw posts (and about a eighth of an inch of the "tripod" plastic around it for support) that attaches the front half and the blade index hole as a guide. I left the top of the disc mostly unmodified (speaker holder and the button mount). The battery compartment was fun...orpexhttps://www.blogger.com/profile/14235298689095579884noreply@blogger.comtag:blogger.com,1999:blog-8119414028775734083.post-39646525109695324372011-02-18T08:05:35.983-06:002011-02-18T08:05:35.983-06:00I actually just posted the code - in that version ...I actually just posted the code - in that version I was using row 1 (index 0) for everything since that is all I had wired up at that point. Row 1 is the front inner C, row 2 is the back inner C (if installed), row 3 is the right half of the blade starting at the index hole, row 4 is the left half of the blade starting where row 3 left off.orpexhttps://www.blogger.com/profile/14235298689095579884noreply@blogger.comtag:blogger.com,1999:blog-8119414028775734083.post-77317931851921891912011-02-17T23:37:59.396-06:002011-02-17T23:37:59.396-06:00Nice work. I'm going to start prepping my dis...Nice work. I'm going to start prepping my disc next week, cutting the plastic out and what not. Excited to give this a shot.<br /><br />I'm assuming that row 3 and 4 are for each of the inner rings?Unknownhttps://www.blogger.com/profile/17490316341763457194noreply@blogger.com